Step-by-step installation instructions.

Faucet Installation

Be sure there is room underneath the sink to make the needed connections.

Select one of the following places to install the faucet:

Spout

—IN an existing sink spray attachment or soap dispenser hole.

 

—IN a hole to be drilled in the sink top.

 

—IN a hole to be drilled in the countertop, next to the sink.

Lever

NOTE: Looking at second illustration at right, be sure the faucet base will fit

 

flat against the surface at the selected location so the gasket will seal.

Faucet

1

If drilling is needed, make a 3⁄4″ dia. hole. Be sure to use the proper

 

procedure for drilling porcelain or stainless steel. Special drill bits

 

 

may be needed.

Faucet

 

 

stud

2

Place small gasket, base and large gasket (in that order) onto the

faucet stem. Next, place lock washer and hex nut onto faucet stud.

 

 

Insert tubing insert into tubing adapter. Securely tighten to faucet stud.

3

 

Feed the length of 3⁄8″ OD tube from the bottom, up through the

4

mounting hole. Connect to the tubing adapter as shown in second

 

 

illustration, tightening the compression nut securely.

 

Remove the short shipping tube and insert the spout into the

5

faucet body. Rotate spout into place.

 

 

Lower the faucet assembly into place on the underside of the mounting

6

hole. Place the mounting bracket above the lock washer. While holding

 

the mounting bracket in place, securely tighten the hex nut.

ASSEMBLED

Small gasket

Base

Large gasket

Sink

Mounting bracket

Lock washer

Hex nut

Tubing insert

Tubing adapter

Compression nut

Tubing adapter

Tubing insert

Compression nut

3/8″ tubing, (run to Filter outlet)

6