![](/images/new-backgrounds/1060126/6012621x1.webp)
Mounting Bracket to Cabinet Wall
The bracket can be used as a template for marking the location of the mounting screws. When determining the location of the bracket make sure you leave
Make Tubing Connections
| Run the length of 3⁄8″ tubing, connected to the bottom of faucet, to the filter system outlet, Fig.1 in the | |
1 | ||
Installation Overview section. Allow enough slack in the tubing to be able to place the system on the floor | ||
| ||
| in front of the sink. Measure and cut the end of the tubing square. | |
| Slide a compression nut onto the end of the tubing and push a tubing insert into the tubing. | |
2 | ||
| Connect the tubing and tighten the compression nuts securely. | |
3 | ||
| Repeat the preceding steps to connect a length of tubing between the filter system inlet and the water | |
4 | ||
| supply/saddle valve, Fig. 1 in the Installation Overview section. |
Fig. 4
Tubing connector
Mounting |
|
bracket | Mounting |
| |
Tubing | screws |
| |
connector |
|
Sump
Sump
Filter ΙΙ
Filter Ι
1
Battery Pack Installation and Connection
| In a dry location, within reach of the electronic base 3′ leadwire, select a place for the battery pack (see | |
1 | ||
Fig. 1 on page 8). The battery pack attaches to most surfaces, using the included | ||
| ||
| strip. | |
| The battery pack uses two size “AA” batteries. Check to be sure they are installed correctly. Then, | |
2 | ||
| remove the paper backing on the Velcro™ strip and secure the pack in place. | |
| Fasten electronic base leadwire and battery pack connector together. | |
3 |
11
Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips
Customer Service