Instructions
Using the clock and timer.
Instructions Safety
To Set the Clock
The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or
Make sure the clock is set to the correct time of day.
Press and hold the TIMER/CLOCK pad.
Press the + and – pads.
Press the START pad.
To check the time of day when the display is showing other information, simply press the TIMER/CLOCK pad. The time of day shows until another pad is pressed.
Care and Cleaning Operating
The timer is a minute timer only.
The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.
To Set the Timer
Press the TIMER/CLOCK pad.
Press the + and – pads until the amount of time you want shows in the display. Maximum time that can be entered in minutes is 59. Cooking times more than 59 minutes should be changed to hours and minutes. For example, enter 90 minutes as 1 hour,
30 minutes.
If you make a mistake, press the TIMER/CLOCK pad and begin again.
Press the START pad.
When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER/CLOCK pad is pressed.
The 6 second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.
To Reset the Timer
If the display is still showing the time remaining, you may change it by pressing the TIMER/CLOCK pad, then press the + and – pads until the time you want appears in the display.
If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the TIMER/CLOCK pad and then pressing the + and – pads until the time you want appears in the display.
To Cancel the Timer
Press the TIMER/CLOCK pad twice.
Power Outage
Consumer Support
If a flashing time is in the display, you have experienced a power failure. Reset the clock.
To reset the clock, press and hold the TIMER/CLOCK pad until the display changes.
Enter the correct time of day by pressing the + and – pads until the time you want appears in the display. Press the START pad.
14