GE JDP47 and Cleaning Troubleshooting Tips Consumer Support, After a Clean Cycle, Safety

www.GEAppliances.com

The oven door must be closed and all controls must be set correctly for the cycle to work properly.

Safety

How to Delay the Start of Cleaning

Press the SELF CLEAN LO/STD pad once for a 4-hour clean time or twice for a 3-hour clean time.

A 3-hour self-clean time is recommended for use when cleaning small, contained spills. A self-clean time of 4 hours or longer is recommended for a dirtier oven.

If a time other than 4 hours or

3 hours is needed, use the number pads and enter the desired clean time.

You can change the clean time to any time between 3 hours and 5 hours, depending on how dirty your oven is.

Press the DELAY START pad.

Using the number pads, enter the time of day you want the clean cycle to start.

Press the START pad.

The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED light

goes off.

When the LOCKED light goes off, you will be able open the door.

Instructions Operating Instructions Care

After a Clean Cycle

You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap-filled steel wool pad and rinse thoroughly with a vinegar and water mixture.

These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

■You cannot set the oven for cooking until the oven is cool enough for the door to unlock.

■While the oven is self-cleaning, you can press the CLOCK pad to display the time of day. To return to the clean countdown, press the SELF CLEAN LO/STD pad.

■If the racks become hard to slide, apply a small amount of cooking oil to a paper towel and wipe the edges of the oven racks with the paper towel.

and Cleaning Troubleshooting Tips Consumer Support

17