GE JP930CCCC dimensions JP930BC/CC/SC/TC-GE Profile 30 Built-In CleanDesign Electric Cooktop

TM

JP930BC/CC/SC/TC—GE Profile™ 30" Built-In CleanDesign Electric Cooktop

Counter Installation (in inches) Cooktop Dimensions (in inches)

KW Rating

13" MAX. depth

30" MIN. to
unprotected	18" MIN.	1-1/2" MIN.
cabinet		clearance to
	to cabinet
1-3/4" to		side wall
		from cut-out
rear wall

1-3/4" MIN. clearance to side wall from cut-out

Electrical junction	Cut should
box 16" MIN.
below countertop	not interfere
	with cabinet
	structure at
	front

29-3/4** 20-7/8**

3-1/4*

Cooktop

19-5/8

28-1/2

2-1/2" Required

*Depth of unit at conduit location (rear) is 4-5/8"

**Stainless steel cooktop dimensions are 29-7/8" (width) and 21-1/2" (depth)

240V	8.1
208V	6.1
Breaker Size
240V	40 Amps†
208V	30 Amps†

†Note: Check local codes for required breaker size

Note: If installing with a GE Profile Performance™ or GE Profile™ Telescopic Downdraft System, consult both cooktop and downdraft installation instructions packed with product before installing. Cooktop gas/electric supply may need

to be re-routed to install downdraft.

Note: Consult cabinet and countertop manufacturer’s specs for flush mount installation prior to install.

Installation Information: Requires a 5" free area between the bottom of the

cooktop to any combustible material, i.e., shelving. Free area not required when installing wall oven underneath cooktop. Refer to installation instructions. Requires an 18" minimum from cooktop to adjacent overhead cabinets. Units are furnished with a 48" flexible armored cable.

Before installing, consult installation instructions packed with product for current

dimensional data. 36" Ribbon cooktops are approved for use over GE 30" Single Wall Ovens only. 30" Ribbon cooktops are approved for use over select GE 29" and GE 30" Single Wall Ovens. Refer to cooktop and wall oven installation instructions packed with product for current dimensional data.

Filler Trim Kit

When replacing an old GE 30" cooktop (with larger opening) with Models JP938/930/350/340, use the following one-piece trim kit to fill in the over-size hole. Available at additional cost.

JXTR31W (True White)

JXTR31B (Black glass with black, white or bisque pattern)

Flush Mount Installation Kit

Accommodates both 30" and 36" installations. Not for use with stainless steel models.

JXFLMTW (True white glass)

JXFLMBB (Black glass with black, white or bisque pattern)

	For answers to your Monogram,® GE Profile™ or
	GE appliance questions, visit our website at		Listed by
	WWW.GEAppliance.com or call
Specification Created 3/01			Underwriters
	GE Answer Center® service, 800.626.2000.	R	Laboratories