GE JSP42SKSS dimensions GE 30 Slide-InElectric Range, Dimensions and Installation Information

JSP42SK

GE® 30" Slide-In Electric Range

Dimensions and Installation Information

Accessory Backguard

KW Rating

240V	11.6
208V	8.7

Models are shipped with color- matched Rear Filler Strip Kit. Optional Kits For Slide-In Electric Ranges

(Available at additional cost)

24

2-7/8"

To Front

Surface Of

Countertop

31-1/4	30	A/B*
					Shave Raised Edge To Clear
			30"	Min.	31-1/8" Wide Control Panel
		Recommended			Excluding Models JSS28 and JSP39
		6" Min.

Lower/Side Trim Kits Accessory Backguards

JXS56 - Lower Trim Kit	JXS37 - Backguard
JXS86 - Vertical Side Trim Kit	JXS77 - Body Sides

Note: To reduce possiblity of scorching of the side wall adjacent to the heating elements, it is recommended a minimum of 6” spacing from adjacent side walls be allowed for possible extended, high-heat, no-load

20-5/8" Door

Clearance

From Front

Surface of

Countertop

From Walls		9/16
36-1/4
		30" Min.
	23-3/16	Acceptable
		Electrical	13" Max.
		Outlet Area	15" Min.

operation of heating elements.

Receptacle Location: For all 30” Slide-In Ranges locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation. See shaded area in drawing for location of electrical outlet box. Recommended outlet locations allow range to be installed directly against rear wall.

Note: Cabinets installed adjacent to slide-in ranges must have an adhesion spec of at least 194°.

Installation Information: Before installing, consult installation instructions packed with product for ­current dimensional data.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service,

If you are NOT using the optional Filler or Backguard:

23-3/16

30

25-3/4**	*JXS37 is 5
(excluding handle) **Total depth
	35-7/8"–38"
	front of clos
	from floor to
	countertop	2-1/2
		30

If you are using the optional Filler or Backguard:25

30

25

7-1/2

2-1/2

800.626.2000.

Dimension and installation information are shown in inches.

All GE ranges are equipped with	Listed by
an Anti-Tip device. The installation	Underwriters
of this device is an important,
required step in the installation	Laboratories
of the range.

Specification Revised 1/08

320642