Instructions Care, Instructions Operating

www.GEAppliances.com

Safety

Removable Oven Floor

To remove the oven floor:

Remove the oven door using the instructions in the Lift-Off Oven Door section.

Press down and pull out the removable oven floor.

Press down and pull out.

Clean the oven floor with warm soapy water.

When reinstalling the oven floor, be sure to slide it all the way to the back of the oven.

IMPORTANT: Always replace the removable floor before the next use.

Instructions Operating

Roasting rack	Oven Racks and Convection Roasting Rack
Oven rack	Clean the oven racks and the convection	NOTE: The oven racks and convection roasting
Oven rack	roasting rack with an abrasive cleanser or	rack may be cleaned in the self-cleaning oven.
	roasting rack with an abrasive cleanser or	rack may be cleaned in the self-cleaning oven.
	plastic scouring pad. After cleaning, rinse	However, the oven racks will darken in color,
	the racks with clean water and dry with a	lose their luster and become hard to slide if
	the racks with clean water and dry with a	cleaned during the self-cleaning cycle.
	clean cloth.	cleaned during the self-cleaning cycle.
	clean cloth.

To make the oven racks slide more easily, apply a small amount of cooking oil to a paper towel and wipe the edges of the oven racks with the paper towel.

Instructions Care

Receptacle

Socket

Oven Light Bulbs (on some models)

NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip.

and Cleaning

Bulb

Tab

Glass cover

CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel.

Be sure to let the light cover and bulb cool completely.

For your safety, do not touch a hot bulb with bare hands or a damp cloth.

To remove:

Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket.

Using gloves or a dry cloth, remove the bulb by pulling it straight out.

To replace:

Use a new 130-volt halogen bulb, not to exceed 50 watts.

Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers.

Receptacle

Use gloves or cloth

Push the bulb straight into the receptacle all the way.

Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn.

For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.

Reconnect electrical power to the oven.

GE JSP57 owner manual Instructions Care, Instructions Operating, Removable Oven Floor

Models: JSP57