GE JT952SKSS Care and Cleaning Troubleshooting Tips, Cleaning the Oven Door, Lift-Off Oven Door

Models: JT952SKSS

1 32
Download 32 pages 13.06 Kb
Page 23
Image 23
Cleaning the Oven Door


Do not rub or clean the door gasket— it has an extremely low resistance to abrasion.

If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.

Cleaning the Oven Door

To clean the inside of the door:

Because the area inside the gasket is cleaned during the self-clean cycle, you do not need to clean this by hand.

The area outside the gasket and the door liner can be cleaned with a soap-filled or plastic scouring pad, hot water and detergent. Rinse well with a vinegar and water solution.

To clean the outside of the door:

Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass

on the outside of the door. Do not let water drip into the vent openings.

If any stain on the door vent trim is persistent, use a soft abrasive cleaner and a sponge-scrubber for best results.

Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.

Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door.

Instructions Operating Instructions


Hinge lock

Pull hinge locks down to unlock

Removal position

Lift-Off Oven Door

The door is very heavy. Be careful when removing and lifting the door.

Do not lift the door by the handle.

To remove the door:

Fully open the door.

Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat- blade screwdriver, may be required.

Firmly grasp both sides of the door at the top.

Close door to the door removal position, which is halfway between the broil stop position and fully closed.

Lift door up and out until the hinge arm is clear of the slot.

To replace the door:

Firmly grasp both sides of the door at the top.

With the


Hinge arm

door at the



same angle as

of slot


the removal



position, seat the


indentation of



the hinge arm



into the bottom


edge of the hinge slot. The notch in

the hinge arm must be fully seated

into the bottom of the slot.


Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.

Push the hinge locks up against the front frame of the oven cavity, to the locked position.

Hinge arm

HingeInstructions Operating Instructions lock

Care and Cleaning Troubleshooting Tips

Push hinge locks up to lock

Close the oven door.

Removable Oven Floor

To remove the oven floor:

Remove the oven door using the instructions in the Lift-Off Oven Door section.

Press down and pull out the removable oven floor.

Press down and pull out.

Clean the oven floor with warm soapy water.

When reinstalling the oven floor, be sure to slide it all the way to the back of the oven.

IMPORTANT: Always replace the


removable floor before the next use.

Consumer Support

Page 23
Image 23
GE JT952SKSS Care and Cleaning Troubleshooting Tips, Cleaning the Oven Door, Lift-Off Oven Door, Removable Oven Floor