Installation Instructions

A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor.

•Read the instructions on the TOP CABINET TEMPLATE.

•Tape it underneath the top cabinet.

•Drill the holes, following the instructions on the

TOP CABINET TEMPLATE.

CAUTION:Wear safety goggles when drilling holes in the cabinet bottom.

A3. CHECK FOR PROPER

DAMPER OPERATION

A4. MOUNT THE MICROWAVE OVEN

CAUTION: FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN.

IMPORTANT: Do not grip or use handle during installation.

NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.

NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks arenot used, case damage may occur from overtightening screws.

NOTE: When mounting

 

the microwave oven,

 

thread power cord

 

through hole in bottom of

 

top cabinet. Keep it tight

1 Lift microwave, tilt it

throughout Steps 1–3. Do

not pinch cord or lift

forward, and hook

oven by pulling cord.

slots at back bottom

Blower Plate

Damper

Exhaust Adaptor

edge onto four lower

tabs of mounting

plate.

Back of

Microwave

Oven

Retaining Hooks

•Place the microwave in its upright position, with the top of the unit facing up.

•Make sure tape securing damper is removed and damper pivots easily before mounting microwave.

•Slide the damper into place. Make sure it catches in the retaining hooks to secure.

•You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed.

2 Rotate front of oven up against cabinet bottom.

3Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet.

13