Installation Instructions
STEP 1 INSTALL CEILING BRACKET
The ceiling bracket must be installed when the duct cover is used to span 24² or more height above the hood. The bracket will hold the decorative duct cover in place at the top.
Note: The ceiling bracket is not required when using only the 12² section of the duct cover.
•Install the 2 small screws into the sides of the duct bracket. Remove the screws.
•Match center notch on the bracket to the centerline on the wall and flush against the ceiling.
•Mark the 2 screw hole locations.
•Drill 1/8² pilot holes in marked bracket location.
•If pilot holes do not enter studs, enlarge the holes to 3/8² and install wall fastener anchors.
•Secure the bracket to the rear wall with wood screws and washers. Use wall anchors if needed.
Note: Bracket has 2 sets of holes. Use larger holes for wall fasteners or wood screws with washers. Use smaller holes for wood screws with washers.
Install
Ceiling Bracket
When Duct
Cover is
Used to Span
24" or More
See Step 2
to Install
Duct Cover
STEP 2 INSTALL DUCT COVERS
To install the 12² duct cover alone:
•Place the 12² section of the decorative duct cover on top of the hood.
•Secure the cover to the top of the hood with 4 screws provided.
To install the
•Place the
•Secure the bottom cover to the top of the hood with 4 screws provided.
•Extend the inside section upwards to meet the ceiling and ceiling bracket.
•Secure the duct cover to the bracket with the 2 small Phillips screws provided.
Pub. No.
Dwg. No. 164D4290P065
(N.D. 245) 6/01