Memorizing channels | GE MG13400, MG19400, MG20100 specification

TV OPERATION

Memorizing channels, continued

33 Press CH ▲ or CH ▼ to select a channel. Press VOL+ to add the channel or –VOLto erase the channel.

Add/Erase

ANT 12 ErasedAdded

Press "Menu" to finish.

✓You can also use the number buttons to enter the channel number.

44 When you are finished, press the MENU button twice to return to normal viewing.

✓You can still view a channel that is not stored in memory. To do so, use the number buttons on the remote control to select the channel.

Fine tuning channels

You can fine tune a channel to make it come in clearer.

1Press CH ▲, CH ▼, or the number buttons to select a channel.

22 Press MENU repeatedly until you see the Setup menu. Press CH ▼ until you select “Fine tune.”

	Video	Channels
		Memorize
	Time	Add/Erase
	Time	Fine tune
		Fine tune
		Caption
	Setup	Language

33 Press –VOLand VOL+ until the channel becomes as clear as possible.

Fine tune

✓When the “slide box” displays a single vertical line, this indicates the “average” fine tuning setting.

44 Press DISPLAY or MENU to clear the menus from the screen.

CHAPTER THREE: TV OPERATION 13

Image 17

GE MG13400, MG19400, MG20100 manual Memorizing channels, Fine tuning channels

Contents

TV User’s Guide Important Safety Information Important Safety InstructionsPower Consumption 100-240V~50-60 Hz Important Safety Instructions Important Safety Instructions Iii. Important Safety Instructions Contents Contents Chapter ONE List of featuresYour NEW TV Checking parts Learning about your new TV Front panel jacks, buttons and indicators Rear panelVideo and Audio input jacks Use these jacks to connect a VCR or other video equipment Number buttons Remote control+100 STD Antennas with 300-ohm flat twin leads Chapter TWO InstallationConnecting VHF and UHF antennas Antennas with 75-ohm round leads InstallationSeparate VHF and UHF antennas Cable without a Converter Box Unplug the cable or antenna from the back of the TV Connecting a VCRConnect a coaxial cable to the VCR’s Antenna OUT terminal Connect an audio cable to the VCR’s Audio OUT terminal Installing batteries in the remote control Connecting a camcorderLocate the camcorder’s A/V output jacks on the camcorder Connect a video cable to the camcorder’s Video OUT terminal Chapter Three TV Operation With the TV’s power on, press the Menu buttonTurning the TV on/off Viewing the menus Selecting the menu language TV OperationPress CH until Language is highlighted Press Display to exit the menus Storing channels in memory Memorizing the channelsAdding and Erasing Channels Press Menu twice to clear the screen Press Display or Menu to clear the menus from the screen Fine tuning channelsMemorizing channels Directly accessing channels Using the channel buttonsChanging channels Scanning the channels Press VOL + Setting the clock Raising or lowering the volume Adjusting the volumeUsing Mute Customizing the picture VOLlowers brightness Using Automatic Picture Viewing the on-screen displays Setting the sleep timerViewing a VCR or camcorder tape To return to normal TV viewing, press TV/VIDEO again Setting the On/Off Timer Chapter Four Special FeaturesPress VOL+ to set the timer to on Press CH to highlight On time. Press VOL + When you are finished setting the timer, press Display Special FeaturesUsing the Skip Timer Press VOL+ to open the Closed Caption menu Viewing Closed CaptionsPress VOL + to turn closed captioning on Appendix TroubleshootingIdentifying Problems Appendix Cleaning and maintaining your TVSpecifications Page Page Page