GFWS3500L/GFWS3505L
GE® 4.9 IEC* cu. ft. stainless steel capacity frontload washer with Steam
Special Installation Requirements:
Stacked Installation:
Kit for stacking dryer over washer is not included with the washer. Order GEFLSTACK.
Alcove or Closet Installation:
•If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
•The dryer MUST be exhausted to the outside.
•Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 3" front and rear
•Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
•Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.
•No other
Bathroom or Bedroom Installation:
81
Pedestal Dimensions (in inches)•The dryer MUST be exhausted to the outdoors.
•The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.
Minimum Clearance other than Alcove or Closet Installations:
• Minimum clearances to combustible surfaces 0" both sides, 3" rear.
For more information on venting kits and accessories, please call
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.
SBSD137HMS - metallic silver SBSD137HMV - vermillion red SBSD137HWW - white
This optional 13" pedestal raises the door opening and height of the washer or dryer. Feet on 13" pedestal allow it to adjust to
27
13
28-3/4
Listed by
Underwriters
Laboratories
Specification Revised 10/10 | 360486 |
