Installation Instructions

TUBING AND FLOW RESTRICTOR INSTALLATION

INSTALLING THE TUBING TO TANK

AND FAUCET

1.Measure 3/4″ from the end of each remaining piece of tubing (faucet end and inlet end) and mark with a pencil. (Check for roundness, smoothness, cuts, nicks, flat spots and sharp edges).

2.Push the tubing firmly into each fitting on the manifold until the line is flush with the fitting collar. (If the tubing is removed, re- cut the end, measure, mark and re-insert). Tubing must be fully inserted to avoid leaks. To remove tubing: depress and hold red or blue collet; pull tubing out to remove.

3.Pull out slightly on tubing to ensure a good seal.

12

/4.