GE PSB42YGXSV dimensions Dimensions and Installation Information, Grounding the Refrigerator

PSB42YGX

The Installation Space

3"

*Finished Width

GE Profile™ 42" Built-In Stainless Side-By-Side Refrigerator with Dispenser

7"

7"

84 1/2" max

Electrical

Dimensions and Installation Information

83 1/2" min

Area

74"

Grounding the Refrigerator

Finished

Opening

From Floor

important—Please read carefully

Side Panels

24"

24"

to Bottom

of Electrical

Side panels (not

for personal safety, this appliance must be

supplied) must be

5"

Water Supply

5"

3 1/2"

properly grounded.

used whenever

The power supply cord of this appliance is equipped

the sides of the

3 1/2"

with a three-prong (grounding) plug which mates with

refrigerator will

*The finished cutout width must be: 41-1/2" for 42" models

a standard three-prong (grounding) wall receptacle to

be exposed.

Water and Electrical Locations

*84"

minimize the possibility of electric shock hazard from

*Depending on

The opening must be prepared with the electrical and

this appliance.

installation

water supply located as shown.

Have the wall outlet and circuit checked by a qualified

height.

The cutout depth must be 24"

electrician to make sure the outlet is properly grounded.

The refrigerator will project forward, slightly beyond

Where a standard 2-prong wall outlet is encountered, it

adjacent cabinets, depending on your installation.

Additional Specifications

is your personal responsibility and obligation to have it

• A 120 volt, 60Hz, 15 or 20 amp power supply is required.

replaced with a properly grounded 3-prong wall outlet.

*3" to 4"

An individual properly grounded branch circuit or circuit

do not, under any

1-1/2"

breaker is recommended. Install a properly grounded 3-

circumstances, cut

Flooring

prong electrical receptacle recessed into the back wall.

or remove the third

Electrical must be located on rear wall as shown.

For proper installation, this refrigerator must be placed

(ground) prong from

Note: GFI (ground fault interrupter) is not recommended.

the power cord.

on a level surface of hard material that is at the same

• Water line can enter the opening through the floor or

height as the rest of the flooring. This surface should be

do not use an adapter plug

rear wall. The water line installed should be 1/4" O.D.

strong enough to support a fully loaded refrigerator, or

to connect the refrigerator

copper tubing or GE SmartConnect™ tubing between

approximately 1500 lbs.

to a 2-prong outlet.

the cold water line and water connection location. The

NOTE: Protect the finish of the flooring. Cut a large

do not use an extension cord

line should be long enough to extend to the front of the

section of the cardboard carton and place under the

refrigerator. Installation of an easily accessible shutoff

with this appliance.

refrigerator where you are working.

valve in the water line is required.

For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.	Total volume and shelf
		Listed by
	area are calculated by
		Underwriters
	the Association of Home
		Laboratories
	Appliance Manufacturers’
	standards.

Specification Created 1/08 210377