GE PSB42YSX dimensions Electrical, Area, Water Supply 5 3 1/2 3 1/2

PSB42YSX

GE Profile™ 42" Built-In Stainless Side-By-Side Refrigerator with Dispenser

The Installation Space

		3"
	*Finished Width
			7"
		7"
84 1/2" max	Electrical

Dimensions and Installation Information Grounding the Refrigerator important—Please read carefully

for personal safety, this appliance must be properly grounded.

The power supply cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Where a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

do not, under any circumstances, cut or remove the third

Side Panels

Side panels (not supplied) must be used whenever the sides of the refrigerator will be exposed.

*Depending on installation height.

Flooring

*84"

24"

*3" to 4" 1-1/2"

83 1/2" min	Area
	74"
Finished
Opening	From Floor
24"	to Bottom
	of Electrical

5" Water Supply 5" 3 1/2"

3 1/2"

*The finished cutout width must be: 41-1/2" for 42" models

Water and Electrical Locations

The opening must be prepared with the electrical and water supply located as shown.

The cutout depth must be 24"

The refrigerator will project forward, slightly beyond adjacent cabinets, depending on your installation.

Additional Specifications

• A 120 volt, 60Hz, 15 or 20 amp power supply is required.

An individual properly grounded branch circuit or circuit

breaker is recommended. Install a properly grounded 3-

prong electrical receptacle recessed into the back wall.

Electrical must be located on rear wall as shown.

(ground) prong from the power cord.

do not use an adapter plug to connect the refrigerator to a 2-prong outlet.

do not use an extension cord with this appliance.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 1500 lbs.

NOTE: Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where you are working.

Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards.

Note: GFI (ground fault interrupter) is not recommended.

• Water line can enter the opening through the floor or

rear wall. The water line installed should be 1/4" O.D.

copper tubing or GE SmartConnect™ tubing between

the cold water line and water connection location. The

line should be long enough to extend to the front of the

refrigerator. Installation of an easily accessible shutoff

valve in the water line is required.

Listed by	As an Energy Star®
	partner, GE has determined
Underwriters
	that this product meets the
Laboratories
	Energy Star guidelines
	for energy efficiency.

Specification Created 1/08 210378