GE PSH25PGW, Collar Trim Installation, Typical Installation, Specification Revised 7/07

PSH25PGW

GE Profile™ Counter-Depth ENERGY STAR® 24.6 Cu. Ft. Side-By-Side Refrigerator

Rough-In Dimensions and Installation Information (in inches)

Collar Trim Installation			Typical Installation
An enclosure is required to match up to the			Shaded areas represent front surfaces of side panels and
trim, see Typical Installation. To obtain the			overhead cabinet or soffit that contacts trim.
most integrated look, the cabinet or soffit
above the refrigerator should extend out
to the same depth as the side panels. The
refrigerator opening must have minimum
dimensions of 70-1/4" high x 36-1/8" wide
x 24-1/2" deep as shown at right. If there is
an overhead cabinet, allow 1" for cabinet
door clearance with the top trim piece so
the cabinet doors can be opened without
hitting the top trim. If 1/2" side panels are
used, then side trim and panel will be even.
If 3/4" side panels are used, then some of
the side panel will extend beyond the trim
and must be finished.
IMPORTANT: Before finalizing specifications
for your GE Profile Counter-Depth				3/4" Cabinet
Refrigerator, please NOTE:		Refrigerator
				Side Panel
		Case				Cabinet
• A minimum of 36-1/8" is required for				1/2" Cabinet	Overhead
						Door
refrigerator installation with collar				Side Panel	Cabinet
• Be sure to allow for 1/2" or 3/4" side		Magnetic				1"
		Tape			Case
panels in addition to the 36-1/8"
minimum.	Door Gasket			Side Trim		Top Trim
				Side trim must be installed

flush with the gasket contact surface on the case.

1/2" minimum

70-1/4"*

24-1/2"*

36-1/8"

*The rough-in dimension of 70-1/4" is minimum and is measured from the finished floor to top of opening (or the underside of the overhead cabinets). For Models with Trim Kit: If frameless style cabinets are planned for above the refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to height of opening to allow additional clearance between cabinet doors and top of refrigerator trim when cabinet doors are in open position.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service,  800.626.2000.

Listed by

Underwriters

Laboratories

Specification Revised 7/07 210219