GE PSI23MGNBB, PSI23MGNWW Collar Trim Installation, For answers to your Monogram, GE Profile or

TM

PSI23MGN—GE Profile Arctica™ 22.7 Cu. Ft. CustomStyle™ Side-by-Side Refrigerator with Dispenser

Collar Trim Installation

An enclosure is required to match up to the trim, see Typical Installation. To obtain the most integrated look, the cabinet or soffit above the refrigerator should extend out to the same depth as the side panels. The refrigerator opening must have minimum dimensions of

70-1/4" high x 36-1/8" wide x 24-1/2" deep as shown at right. If there is an overhead cabinet, allow 1" for cabinet door clearance with the top trim piece so the cabinet doors can be opened without hitting the top trim. If 1/2" side panels are used, then side trim and panel will be even. If 3/4" side panels are used, then some of the side panel will extend beyond the trim and must be finished.

1/2" minimum

70-1/4"*

24-1/4"*

36-1/8"

*The rough-in dimension of 70-1/4" is minimum and is measured from the finished floor to top of opening (or the underside of the overhead cabinets). For Models with Trim Kit: If frameless style cabinets are planned for above the refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to height of opening to allow additional clearance between cabinet doors and top of refrigerator trim when cabinet doors are in open position.

3/4" Cabinet

RefrigeratorSide Panel

Case

1/2" Cabinet

Side Panel

Magnetic

Tape

Door Gasket Side Trim

Side trim must be installed flush with the gasket contact surface on the case.

Cabinet

Overhead Door

Cabinet

1"

Case

Top Trim

IMPORTANT: Before finalizing specifications for your GE Profile CustomStyle Refrigerator, please NOTE:

•A minimum of 36-1/8" is required for refrigerator installation with collar

•Be sure to allow for 1/2" or 3/4" side panels in addition to the 36-1/8" minimum

Typical Installation

Shaded areas represent front surfaces of

side panels and overhead cabinet or soffit that contacts trim.

For answers to your Monogram,® GE Profile™ or

GE appliance questions, visit our website at

GEAppliances.com or call

GE Answer Center® service, 800.626.2000.

Specification Created 11/01

VOLUME and

SHELF AREA

Manufacturer Certified to

ASSOCIATION OF HOME

APPLIANCE MANUFACTURERS

ANSI/AHAN HRF-1-1979

Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards.

Listed by

Underwriters

RLaboratories