Care and Cleaning
www.geadvantium.com
Charcoal filter (JX81A)
The charcoal filter cannot be cleaned. It must be replaced. Order Part No. WB2X9883 from your GE supplier.
If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors.
The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6 to
12 months, depending on usage).
To remove the charcoal filter
To remove the charcoal filter, first disconnect power at the main fuse.
Remove the top grille by removing the 2 screws that hold it in place.
You may need to open the cabinet doors to remove the screws.
Slide the filter towards the front of the oven and remove it.
Remove 2 grille screws to
remove the grille.
To install the charcoal filter
Optional kits
To install a new filter, remove plastic and other outer wrapping from the new filter.
Insert the filter into the top opening of the oven as shown maneuvering it behind the plastic grille until it fits squarely into place.
It will rest at an angle behind the plastic grille on two side support tabs and in front of the right rear tab. Replace the grille and 2 screws. Reconnect power at the main fuse.
Available at extra cost from your GE supplier.
Filler Panel Kits
■
■
■
When replacing a 36″ range hood, filler panel kits fill in the additional width to provide a custom
For installation between cabinets only; not for
Filter Kits
■
Filter kits are used when the oven cannot be vented to the outside.
Decorative Panel Kit
■
When replacing a Hi/Low range, the decorative panel kit fills in the area between the oven and the range left by the Hi/Low model.
42