LOOSE PARTS KIT
DESCRIPTION | QTY | USE |
|
|
|
Steering wheel | 1 | On steering shaft |
Roll Pin | 1 | Secure steering wheel to shaft |
Stone guard assembly | 1 | Fitted to cutterhead |
Spring stone guard | 1 | On stone guard pivot rod |
“E” Clip | 1 | In groove in pivot rod |
Ignition keys | 2 | To start machine |
Plug spanner | 1 | Plug removal and fitting |
Pop Rivets | 2 | Seat safety switch |
|
|
|
SETTING UP INSTRUCTIONS
Fig. 2 | Fig. 4 |
INSTALLING STEERING WHEEL
1.Slip the steering wheel over the steering shaft and align the wheel hole with the shaft hole.
2.Insert a drift punch – partially through the holes to maintain alignment and insert the roll pin in the opposite side. Fig. 2
3.Drive the roll pin in until flush with the outside of the wheel.
INSTALLING STONE GUARD
1.Slip the spring into the stone guard pivot rod so that the short leg rests on top of the stone guard.
2.Now twist the spring as shown and feed the end of the pivot rod into the forward pivot bracket. Fig 3.
3.Insert the short end of the pivot rod fully into the rearward pivot bracket.
4.Release the spring. It should spring down onto the top of the cutterhead and be tensioning the stone guard down.
5.Secure by clipping the “E” Clip into the groove on the pivot rod. Fig. 4.
Fig. 3
3
