SCA2000BCC - GE Profile Performance™ Advantium™ Oven
Dimensional Information (in inches)
66" MIN. | 30" | |
Mounting | ||
MIN. | ||
height | ||
width | ||
from | ||
required | ||
floor | ||
|
12"
MAX.
Door open | ||
|
Exhaust outlet
connects to
Installation Requirements:
1.A minimum of 30” between the cabinets is required for the installation. If the space between the cabinets is than 30”, a Filler Panel Kit may be used to fill the gap between the oven and the cabinets. Your Owner’s Manual contains the kit number for your model.
2.Make sure the bottom edge of the cabinet that will be above the oven will be at least 66” from the floor and 30” from the cooking surface.
3.For easier access to change the hood and range lamps, the bottom of the oven should be at least 2” above the range backsplash.
4.If you are going to vent your oven to the outside, see exhaust duct preparation instructions.
5.When installing the oven beneath smooth, flat cabinets, be careful to follow the instructions on the top cabinet template for power cord clearance.
6.For best installation results, we recommend a maximum cabinet depth of 12”.
Installation Information: This information is not intended to be used for installing unit described. Before installing, consult installation instructions packed with product/kit for current dimensional data.
Electrical Requirements:
Product rating is 240/208 volts AC, 60 Hertz, 30 amps and 6.5 kilowatts. This product must be connected to an individual properly grounded branch circuit, protected by circuit breakers or time delay fuses. Wire size must conform to the requirements of the National Electric Code or the prevailing local code for kilowatt rating. The outlet box should be located in the cabinet above the oven. The supply circuit and outlet box should be installed by a qualified electrician and conform to all prevailing electrical codes. The wall outlet receptacle recommended for this appliance is
WARNING - PLEASE READ CAREFULLY.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED TO AVOID SEVERE OR FATAL SHOCK.
Insure proper ground | NEMA | |
Wall Receptacle | ||
exists before use. | ||
|
DO NOT UNDER ANY CIRCUMSTANCES, CUT, DEFORM, OR REMOVE ANY OF THE PRONGS FROM THE POWER CORD. DO NOT USE WITH AN EXTENSION CORD.
For answers to your Monogram,®
GE Profile Performance Series,™
GE Profile™ or GE appliance questions, call
GE Answer Center® service, 800.626.2000.
Specification Revised 11/99
R
Listed by Underwriters Laboratories