GE ZSC1000, SCB1001 Remove The Packaging, Installation Preparation, Prepare The Opening Cont

Installation Preparation

PREPARE THE OPENING (CONT.)

Installation over a GE/Monogram Oven:

27” or 30”			23-1/2”		Construct
					Solid Bottom
					Min. 3/8”
					Plywood
					Supported
			25-1/8”		by 2 x 4 or 1
					x 2 Runners
					all Four
					Sides
	17-	1/2”				2” Min.
				Per Oven
				Requirement
45-1/4”
Min.

*If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 120 and a single oven, use the dimensions shown.

The middle rail separating the two openings may need to be larger than the 2" minimum shown.

PREPARE THE OPENING (CONT.)

Installation over a GE/Monogram Oven and Warming Drawer:

		Construct
27” or 30”	23-1/2”	Solid
		Bottom
		Min. 3/8”
		Plywood
		Supported
	25-1/8”	by 2 x 4 or 1
		x 2 Runners
		all Four
		Sides
17-1/2”		2” Min.
		Per Oven
		Requirement
45-1/4”		2” Min.
9-1/4”

NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location does not obstruct the required interior depth and height. See Warming Drawer installation instructions for details.

CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 75 pound product, plus, additional oven loads of up to 50 pounds or a total weight of 125 pounds.

MISE EN GARDE : Pour votre sécurité personnelle, la surface de montage doit être capable de supporter le poids du cabinet, en plus du poids supplémentaire du produit, soit 34 kg, en plus du poids supplémentaire du four pouvant aller jusqu’à 22,7 kg, ou un poids total de 56,7 kg.

REMOVE THE PACKAGING

•Lift the oven out of the carton.

•Remove all packing material and tape.

•Open the door and remove parts box.

•Locate parts package containing mounting screws.

7