Safety Information
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•IMPORTANT – Save these instructions for local inspector’s use.
•IMPORTANT – Observe all governing codes and ordinances.
•Note to Installer – Be sure to leave these instructions with the Consumer.
•Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
•Skill Level – Installation of this appliance requires basic mechanical and electrical skills.
•Completion time – 1 hour.
•Proper installation is the responsibility of the installer.
•Product failure due to improper installation is not covered under the Warranty. See Owner’s Manual for warranty information.
IMPORTANT
•Use this oven only for its intended purpose.
•Never use the oven for warming or heating a room Prolonged use of the oven without proper ventilation can be hazardous.
CAUTION:
For personal safety, remove house fuse or oven circuit breaker before beginning
installation to avoid severe or fatal shock injury.
CAUTION:
For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of the 75 pound
product, plus additional oven loads of up to 50 pounds or a total weight of 125 pounds.
CAUTION:
For personal safety this product cannot be installed in cabinet arrangements such as an
island, a peninsula or below a countertop.
MISE EN GARDE :
Pour votre sécurité personnelle, retirez les fusibles de la maison ou le disjoncteur du
four avant l’installation, pour éviter des blessures graves ou même le décès pouvant être causé par un choc électrique.
MISE EN GARDE :
Pour votre sécurité personnelle, la surface de montage doit être capable de supporter le
poids du cabinet, en plus du poids supplémentaire du produit, soit 34 kg, en plus du poids supplémentaire du four pouvant aller jusqu’à 22,7 kg, ou un poids total de 56,7 kg.
MISE EN GARDE :
Pour votre sécurité personnelle, ce produit ne peut être installé dans des arrangements
d’armoires dont un îlot, une péninsule ou le dessous d’un comptoir.
CONTENTS
Design Information |
| Installation Instructions |
|
Models Available | 3 | Step 1, Slide the Oven into the Cutout | 8 |
Product Dimensions and Clearances | 3 | Step 2, Install Bottom Trim | 8 |
Tools Required | 3 | Step 3, Install Side Trim | 9 |
Parts Supplied | 3 | Step 4, Install Mounting Screws | 9 |
Advance Planning | 4 | Step 5, Finalize Installation | 9 |
Installation Preparation |
|
|
|
Electrical Requirements | 5 |
|
|
Prepare the Opening | 6 |
|
|
Remove the Packaging | 7 |
|
|
2
