Safety Information
CAUTION:
For personal safety, remove house fuse or
oven circuit breaker before beginning
installation to avoid severe or fatal shock injury.
CAUTION:
For personal safety, the mounting surface
must be capable of supporting the cabinet
load, in addition to the added weight of the 75 pound
product, plus additional oven loads of up to 50 pounds
or a total weight of 125 pounds.
CAUTION:
For personal safety this product cannot be
installed in cabinet arrangements such as an
island, a peninsula or below a countertop.
MISE EN GARDE :
Pour votre sécurité personnelle, retirez les
fusibles de la maison ou le disjoncteur du
four avant l’installation, pour éviter des blessures
graves ou même le décès pouvant être causé par un
choc électrique.
MISE EN GARDE :
Pour votre sécurité personnelle, la surface de
montage doit être capable de supporter le
poids du cabinet, en plus du poids supplémentaire du
produit, soit 34 kg, en plus du poids supplémentaire du
four pouvant aller jusqu’à 22,7 kg, ou un poids total de
56,7 kg.
MISE EN GARDE :
Pour votre sécurité personnelle, ce produit
ne peut être installé dans des arrangements
d’armoires dont un îlot, une péninsule ou le dessous
d’un comptoir.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
• IMPORTANT– Save these instructions for
local inspector’s use.
• IMPORTANT– Observe all governing codes
and ordinances.
•Note to Installer – Be sure to leave these
instructions with the Consumer.
•Note to Consumer – Keep these instructions with
your Owner’s Manual for future reference.
•Skill Level – Installation of this appliance requires
basic mechanical and electrical skills.
•Completion time – 1 hour.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty. See Owner’s Manual
for warranty information.

IMPORTANT

• Use this oven only for its intended purpose.
• Never use the oven for warming or heating a room
Prolonged use of the oven without proper ventilation
can be hazardous.
2

CONTENTS

Design Information
Models Available.............................................................. 3
Product Dimensions and Clearances............................ 3
Tools Required .................................................................. 3
Parts Supplied .................................................................. 3
Advance Planning .......................................................... 4
Installation Preparation
Electrical Requirements ................................................ 5
Prepare the Opening ...................................................... 6
Remove the Packaging.................................................... 7
Installation Instructions
Step 1, Slide the Oven into the Cutout.......................... 8
Step 2, Install Bottom Trim.............................................. 8
Step 3, Install Side Trim .................................................. 9
Step 4, Install Mounting Screws.................................... 9
Step 5, Finalize Installation ............................................ 9