Installation Instructions
4 LEVEL THE WASHER OR DRYER
ALocate the 4 legs from the parts package and install.
BStand the washer or dryer upright. Move it close to its final location.
CMake sure that the washer or dryer is level by placing a spirit level on top. Check side to side and front to back.
DUse an open ended wrench to adjust the legs
in and out. Tighten the lock nut against the bottom of
the pedestal.
NOTE:
•To minimize vibration, the locking nuts must be tight.
•To reduce vibration, ensure that all four rubber leveling legs are firmly touching the floor. Push and pull on the back right and then the back left of your washer or dryer.
5 REINSTALL THE DRAWER
ACheck to
be sure the slides are closed.
B Slide the drawer
into the Drawer
divider
opening. Align the drawer supports to the slides on each side.
CReinstall the original screws into each drawer slide. Tighten both screws.
DOpen the drawer fully. Slide drawer divider into slots in the center of the drawer. The drawer should slide smoothly when you push it closed.
6 REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the unit.
7 FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions to complete the installation.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
3
