11
1. Drill two holes 315/16
inches (100 mm)
apart. Then thread a
screw into each hole,
letting the heads ex-
tend about 3/16 inch (5
mm) from the wall.
2. Remove the mounting bracket by
holding in both tabs and gently pull-
ing out the wide end of the bracket.
3. Plug one end of the supplied long
modular cord into the telephone jack
on the back of the base.
4. Insert the supplied AC adapter’s
barrel plug into the DC 9V jack on
the back of the base.
5. Route the modular cord through the
groove below the strain relief slot
and the adapter cord through the left
groove on the bottom of the base.
6. Insert the tabs on the narrow end of
the bracket into the inner pair of
slots near the top of the base as
shown and snap the tabs at the wide
end of the bracket into place.
3/16"
315/16"
Strain
Relief
Slot
43-732.fm Page 11 Friday, August 13 , 1999 1:42 PM