CAm Am CLEAN~G
(continued)
Condenser
The condenser is located behind the base grille. For most efficient operation, you need to keep the condenser clean. Remove the base grille and either sweep away or vacuum up dust that is readily accessible. For best results, use a brush specially designed for this purpose. It is available at most appliance parts stores. This easy cleaning operation should be done at least once a year.
Drawer and Cover Removal
Drawers will stop before coming all the way out of refrigerator to help prevent contents from spilling onto floor. Drawers can easily be removed by tilting up slightly and pulling past “stop” location.
To remove drawers when the fresh food compartment door cannot be opened fully:
1.Remove food from the shelf above the Moist ‘n Fresh drawer and take out the shelf. Take food off of the glass cover and out of the drawer.
2.Remove the flexible gasket at the rear of the Moist ‘n Fresh drawer. Lift each end straight up until the slots on the gasket are free of the drawer support tabs.
3.Pull the drawer partway out, Reach in, push the rear of the glass up and, at the same time, push it back until it clears the front corner retainers.
4.Tilt and remove the cover.
5.Pull the drawer forward, lift
the front to clear stops, and remove the drawer. If the refrigerator door doesn’t open completely, pull the drawer out until it hits the door. Then lift the drawer up until it is higher than than the drawer supports, tilt it and take it out.
6.If tape holds Convertible Meat Pan cover to drawer supports, remove the tape. Pull drawer partway out. Reach in, push the rear of the glass up and, at the same time, back, until it clears
7. Tilt and remove the cover.
8.Tilt and remove the drawer.
After cleaning, replace in reverse order.
9.Reinstall the gasket at the rear of the vegetable drawer. Fit the end of the plastic drawer support into the slot on the gasket, with the rubber gasket flap facing you. Make sure the gasket snaps into place.
(continued next page)
16
