GE TNX22PACBB dimensions Case Dimensions in inches/cm, Rough-In Dimensions in inches/cm, 26-3/4

TNX22PACWW - GE Profile Performance™ 21.9 Cu. Ft. CustomStyle™ No-Frost Top-Freezer Refrigerator

Case Dimensions (in inches/cm.)

Rough-In Dimensions (in inches/cm.)

Front View

69-7/8

68-3/4

36-1/4 35-3/4

23-3/4
	26-3/4	28-5/8
			61

8' Ceiling

12" Soffit

13" to 14" Cabinet

70-1/4"*

24"

36"

WaterElectrical

3/4" Airspace

(1/2" Gap + 1/4"

Wall Plates)

24"	25"
Cabinet
	Counter
24-1/2"* Side panels
	Top

Standard, New Construction and Replacement InstallationInstallation Tips to Maximize the Built-In Look

•All wall/floor moulding should be removed prior to installation.

•Water recess on rear wall recommended to prevent water line damage. 48" minimum length 1/4" diameter water line tubing recommended.

•When possible, recess both copper water line and electrical outlet. (See local codes)

•Front and rear leveling legs are adjustable for the built-in look. (See owner’s manual)

Handle Side Clearance

–At least 2" (51 mm) on the handle side for fingertip clearances.

Top and Bottom Clearance

–At least 3/16" (4.75 mm) at the top and bottom edges to allow for trim flange.

Hinge Side Clearance

–The installation of 3/4" (19 mm) thick side panels requires less clearance because the space between the door and adjacent countertop is wider.

•To avoid door contact to countertop consider: –Miter the corner of the adjacent countertops 45°, or –pull the refrigerator forward enough to avoid contact.

IMPORTANT: Before finalizing specifications for your GE Profile Performance™ CustomStyle™ Refrigerator, Please NOTE:

•A minimum of 36" is required for refrigerator installation

•Be sure to allow for 1/2" or 3/4" side panels in addition to the 36" minimum

For answers to your Monogram,®

GE Profile Performance Series,™

GE Profile™ or GE appliance questions, call

GE Answer Center® service, 800.626.2000.

Top View

Specification Revised 11/99

Total volume and shelf

	VOLUME and	area are calculated by the		Listed by
	SHELF AREA
		Association of Home		Underwriters	®
Manufacturer Certified to		Appliance Manufacturers’	R	Laboratories
ANSI/AHAN HRF-1-1979
ASSOCIATION OF HOME
APPLIANCE MANUFACTURERS				C	U
		standards.