Page 8For technical questions, please call 1-800-444-3353.SKU 66619
REv 09c
Connect the Generator only to a 5.
load or electrical system (120 V~)
that is compatible with the electrical
characteristics and rated capacities of
the Generator.
Set up the Generator outdoors in a well-6.
ventilated, dry area, away from building
air intakes. The Generator should be
protected from direct exposure to rain
and snow. Do not set up the Generator
on a conductive surface such as a metal
deck.
operation:
Do not attempt to connect or disconnect 1.
load connections while standing in water,
or on wet or soggy ground.
Do not touch electrically energized parts 2.
of the Generator and interconnecting
cables or conductors with any part of
the body, or with any non-insulated
conductive object.
Use only Class BC or Class ABC re 3.
extinguishers on electrical res.
Do not overload the Generator. 4.
Overloading can cause res in the
electrical cords, in addition to Generator
and appliance damage.
Service:
Keep all electrical equipment clean
and dry. Replace any wiring where the
insulation is cracked, cut, abraded, or
otherwise degraded. Replace terminals
that are worn, discolored, or corroded.
Keep terminals clean and tight.
bASIc SPEcIFIcATIoNS
Fuel
Required
Mixture
(50:1)
50 Parts 89+ octane
unleaded gasoline
mixed with 1 part
2-cycle oil
Capacity 1.1 Gallons
Note: Additional specications found in the
TECHNICAL ENGINE SPECIFICATIONS
chart in this manual.
The emission control system for this
engine is warranted for standards set by the
U.S. Environmental Protection Agency and
by the California Air Resources Board (also
known as CARB). For warranty information,
refer to the last pages of this manual.
At high altitudes, the engine’s carburetor,
governor, and any other parts that control
the fuel-air ratio will need to be adjusted by
a qualied mechanic to allow efcient high-
altitude use and to prevent damage to the
engine and any other devices used with this
product.
UNPAcKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353l as soon as
possible.