Page 9For technical questions, please call 1-800-444-3353.SKU 66619
ITEM RUNNING
WATTS
START-UP
WATTS
Ten 75 Watt Light Bulbs 750
1/4HP Compressor 600 900
1/6HP Motor 500 800
3/8” Drill 400 600
Mini Refrigerator 400 700
15 Amp Battery Charger 380
String Trimmer 350 500
Table/Box Fan 200 300
Radio 50
NoTE: Wattages listed above are estimates
for that type of equipment only. Check
nameplate wattages on all loads before
connecting to Generator.
oPERATING INSTRUcTIoNS Read the ENTIRE IMPoRTANT
SAFETY INFoRMATIoN
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
To PREvENT
SERIoUS INjURY:
operate only with proper spark
arrestor installed. operation of
this equipment may create
sparks that can start res around
dry vegetation.
The operator should contact
local re agencies for laws or
regulations relating to re
prevention requirements.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Starting the Engine
Inspect the Generator looking for
damaged, loose, and missing parts
before set up and starting. If any
problems are found, do not use the
unit until properly repaired.
checking and Filling The Fuel Tank:
cAUTIoN! Your Warranty is VOID if the
Engine’s Fuel Tank (73) is not lled with
the proper mixture (50:1) of unleaded
gasoline and 2-cycle oil before each
use. Before each use, check the fuel
level. Do not run the Engine with an
improper unleaded gasoline/2-cycle oil
mixture. Running the Engine with an
improper mixture WILL permanently
damage the Engine.
The Fuel Tank (73) holds approximately 1.
1 gallon of fuel.
FIGURE b
1 GAlloN
UNlEADED
GASolINE
2.5 FlUID oUNcES
2-cYclE oIl
APPRovED
coNTAINER
2. To obtain the proper gasoline and
2-cycle oil mixture, mix 2.5 uid ounces
of 2-cycle oil with 1 gallon of unleaded
gasoline into an approved container.
Then slowly shake the container to
thoroughly mix the gasoline/2-cycle oil.
(See Figure b.)
REv 10b