GE TFJ25PA, TPJ24BI, TFJ22JA, TFJ20JA specifications Instructions For Installation, Read Before Using

INSTRUCTIONS FOR INSTALLATION

1 5

Refrigerator should be installed on a firm and level floor.

Straight!

If the floor is not firm, noise or vibration may occur. When opening and closing the door, the refrigerator may topple and cause injuries.

Install in a low-humidity location.

An electrical short circuit or rusting may occur. If it is necessary to install in a washroom or on a damp floor, be sure to provide gaps by placing the refrigerator on some sort of blocks.

CAUTION: This type of refrigerator uses forced fan cooling. Therefore, to prevent reduction in the cooling capacity, place the refrigerator on top of a firm board before placing it on blocks. Do not place the refrigerator directly on top of the blocks.

2

Place a firm board under the refrigerator when installing it on a weak floor, on a tatami, or on a carpet.

If the refrigerator is installed directly on carpet or other mats, the compressor under the refrigerator may touch the mat, causing discoloration of the mat, or may interfere with the cooling capability by reducing air flow.

6

Allow sufficient space around the refrigerator as shown in diagrams below.

		Icemaker	Stop Valve	Stop Valve for
Wall Outlet			for Icemaker
		50~100	if installed	Icemaker		Z
	Y			50~100
X	X	X	X
Units: mm	X = 16 (TFJ20, TFJ22, TFJ25), = 3 (TPJ24)				50	Y
	Y = 25 (TFJ20, TFJ22, TFJ25), = 13 (TPJ24)					50~100
	Z = 25 (TFJ20, TFJ22, TFJ25, TPJ24)
						If Icemaker is installed

Read Before Using

3

If the refrigerator is tilted, adjust with leveling screws under the front end. The front end of the refrigerator should be slightly higher so the door will close when lightly pushed.

Rotate	Rotate
clockwise	clockwise
to raise	to raise
	Leveling Screws

7

To avoid electric shock, ground the refrigerator.

Consult dealer for grounding installations. (Fee will be charged for grounding installations.)

NOTE: A grounding wire is attached to this refrigerator. Please connect these grounding terminals correctly.

4

Install away from heat sources.

Avoid locations in direct sunlight or near heat-producing appliances (range, heater, etc.). Cooling efficiency may be lowered or external color changes may result.

8

Do not put anything in front of the grille.

Since air is suctioned in from the front of the grille, obstructing the grille could lower the cooling capacity.

12