GE ZBD3900, ZBD3540, ZBD3500 manual problem, Questions ?, Use this

Models: ZBD3900 ZBD3500 ZBD3540

1 24
Download 24 pages 58.6 Kb
Page 17
Image 17
problem

Questions ?

PROBLEM

Use this

Stained tub interior

 

problem

so[_er

POSSIBLE CAUSE

Detergent with colorant was used

Some tomato-based foods can stain

WHAT TO DO

.Some detergents contain colorant

(pigment or dyes) that will discolor tile mb interior with extended use. Check tile

detergent cup fbr signs of any discoloration. If cup is discolored, change to detergent widlout a W colorant.

"Use of the RINSE & HOLD wcle (on some models) after adding tile dish to tile load can decrease tile level of staining.

Dishes and flatware not clean

Spots and filming on glasses and flatware

Inlet water temperature is below 120°F.

Water pressure is

temporarily low

Air gap is clogged

Improper rack loading

Extremely hard water

Low inlet water

temperature

Overloading tlle dishwasher

Improper loading

Old or damp powder detergent

Rinse agent dispenser empty

Too little detergent

.Raise tile water heater temperature to 120°F.

.Use HI TEMP WASH.

.Turn on a fm._cet. Is water coming out more slowly than usual? If so, wait until

pressure is normal be%re using your dishwasher.

.Clean tile air gap.

.Make sure large dishware does not

block tile detergent dispenser or tile wash arm.

Use JET-DRY _ rinse agent to remove spots and prevent new film build-up.

To remove stubborn spots fl'om glassware:

f Remove all metal utensils fi'om tile dishwasher.

2 Do not add detergent.

3 Select tile POT PANS cycle and HEATED DRY opuon.

4 Start tile dishwasher and allow to run fur 26 minutes. Dishwasher will

now be in tile main wash.

Open tile door and pour 2 cups (500 ml)of white vinegar into tile

bottom of tile dishwasher.

Close tile door and allow to complete tile cycle. If vinegar rinse doesn't work: Repeat as above, except use 1/4 cup (60 ml) of citric acid custals instead of vinegar.

17

Page 17
Image 17
GE ZBD3900, ZBD3540, ZBD3500 manual problem, Questions ?, Use this