Reversing the Door Swing
Beverage Center
To reverse the door
To remove the door:
1.Remove 2 screws holding toekick.
2.Remove hinge plug cover on top left side of cabinet.
3.Flatten the shipping carton to use as a pad for the door.
4.Remove the 3 screws holding the top case hinge.
5.Lift off case hinge, it will not be used again.
6.Lift door off bottom case hinge.
7.Remove bottom case hinge and cam riser.
8.Remove fill plug and screw on top right side of door.
Install
3 Hinge
Screws
Remove
Top Hinge
Hinge | Cam |
Pin | Riser |
Remove
Hinge
9.Remove door hinge, door stop and screw from bottom right side of door.
Rotate the door:
Handle will be on right side of door, hinges will go on the left.
To reinstall the door:
1.Install bottom case hinge from kit and cam on the left side of the unit.
2.Install door hinge and door stop to bottom left of door.
3.Install fill plug on top left of door.
4.Place door on bottom case hinge.
5.Install top case hinge from kit on top left of cabinet.
6.Install hinge plug cover on top right of unit.
7.Move plug on toekick to opposite side.
8.Install toekick. Verify that spacers are attached to screw holes.
9.Install Monogram nameplate on door.
10.Put remaining case hinges in bag for possible future use.
Note: Verify that door is on straight and screws are tightened. If not, the door will sag.
Position new nameplate:
Remove the old nameplate and stick the new Monogram nameplate on the door using the template included.
13
