Care and Cleaning
Ice maker
Ice maker system care
CLEANING NEEDED will illuminate when the electronic control senses that the need for cleaning is approaching. At this time you need to purchase Nickel Safe Ice Machine Cleaner by Nu Calgon, available at most appliance repair shops or through GE Parts and Accessories. Order part number WX08X42870. In the U.S.A., call 1.800.626.2002. or visit GEApplianceParts.com. In Canada call 1.800.561.3344. The ice maker must be cleaned, otherwise ice production may decrease significantly or stop.
REPLACE FILTER will illuminate when the electronic control senses that the filter needs to be replaced. At this time you need to purchase a replacement filter, part number IMWF, through GE parts at www.gewaterfilters.com or in the US call 1.800.626.2002.
Product designed and tested for use with genuine GE water filters.
Exterior surfaces
.HHSWKHRXWVLGHFOHDQWipe with a clean cloth lightly dampened with mild liquid dish detergent. Dry with a clean, soft cloth. Do not wipe the ice maker with a soiled dish cloth or wet towel. These may leave a residue that can damage the finish. Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and damage the finish.
6WDLQOHVVVWHHO³Regularly clean and polish the stainless steel door panels and handles (on some models) with a commercially available stainless steel cleaner such as Stainless Steel Magic™ to preserve and protect the fine finish. Order part number WX10X15. In the U.S.A. call 1.800.626.2002 or visit GEApplianceParts.com. In Canada call 1.800.561.3344.
'RQRWXVHDSSOLDQFHZD[RUSROLVKRQWKH stainless steel.
Interior components
WARNING: Disconnect electrical power to the ice maker before cleaning. Failure to do so can result in death, fie, or electrical shock.
AVERTISSEMENT !
Débranchez l'alimentation électrique à la machine à glaçons avant le nettoyage. L’omission de prendre cette précaution peut entraîner la mort, l'incendie ou le choc électrique.
1.Open the storage bin door and remove any ice that is in the bin.
2.Pull out on the bottom of the cutter grid cover until the snaps release to remove.
3.Remove ice scoop and ice scoop holder. Remove the two screws using a 1/4" ratchet.
NOTE: Do not remove hoses. Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F (63°C).
4.With mild soap and warm water wash the storage bin, ice scoop and holder, cutter
grid cover, door gasket, and secured interior components (cutter grid, exterior of hoses, and water reservoir). Rinse with clean water.
5.Clean the same parts again with a solution of
1 tbsp. (15 ml) of household bleach in 1 gal. (3.8 L) warm water. Rinse thoroughly with clean water.
6.Gently wipe the control panel with a soft, clean dishcloth using warm water and a mild liquid dish detergent.
7.Replace ice scoop holder.
8.Replace the cutter grid cover by aligning top tabs and pushing to snap into place.
9.Plug in ice maker or reconnect power.
NOTE: The air cooled condenser needs to be cleaned regularly for efficient ice production and energy conservation. See Care and Cleaning - Condenser section.
9
