Installation Instructions
STEP 1 MOVE REFRIGERATOR INDOORS
IMPORTANT: Door and passageways into the installation location require a 36" min. opening. If the opening is less than 36", the top cap and doors may need to be removed.
NOTE: Skip this step if door removal is not required. See instructions on next page, ÒTo Move The Refrigerator Indoors."
To prevent damage, leave inside packaging, door spacer and outside protective wrap in place until the unit is moved to the installation location.
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best to remove one door at a time.
A. Remove two screws on top of the refrigerator, one on each side.
Push the top cap forward and lift up from the rear. B. Remove 2 screws holding the top filler strip, lift off. C. Open both doors. Remove the 2 toekick screws and
pull forward to remove.
D. Disconnect the water line coupler by pushing against the collar on the left side. Disconnect wire harness.
E. Remove 2 screws holding top hinge to the case. Carefully, lift off door.
Follow the same procedure to remove the fresh food door.
A
B
Hinge Screws
E
D
C
Toekick Screw
Wire Harness Water Line Coupler
5
