Installation
Instructions
ACCESSORY PANEL KITS
ZPSS360 – Stainless Steel ZPBS360 – Black Acrylic
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•Note to Installer – Be sure to leave these instructions with the Consumer.
•Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
Kit Contents | Tools Required |
• 2 Filler panels | • Phillips screwdriver |
(with ZPSS360 only) | • Safety glasses |
• Door panel | • Gloves to protect against |
• Grille panel | sharp edges |
| • Wood block |
| • Hammer |
|
|
STEP 1 REMOVE HANDLES AND TRIM
•Open the door to 90°. Remove the 6 Phillips head screws from the door handle.
•Remove handle. Retain all screws.
•Remove 6 screws holding trim. Lift off trim. Retain screws.
STEP 2 INSTALL PANELS
•Remove protective film from appearance panel.
•Slide panel into the door trim.
•If installing stainless steel panels, first slide filler panel into the door trim, then slide stainless panel into the trim.
•If necessary, tap with a wood block until panel slips under the hinge side trim.
Use Front Holes to Secure Trim
Use Rear Holes
to Secure Handle
•There are two sets of holes in the handle side trim. Replace side trim by installing the original screws in the FRONT screw holes.
•Secure the handle to the door using the REAR screw holes.