STEP 3 INSTALL GRILLE PANEL
•Remove the protective film from the appearance panel.
•Raise the grille panel to the stop position.
•Loosen the screws on the side trim behind the frame. Remove the bottom trim.
•Slide the panel over the metal backer panel and into the trim.
•If installing Stainless steel panels, first slide the filler panel into the trim, then slide the stainless panel into the trim.
•If necessary, tap with a wood block until the panel slips under the top trim piece.
•Reassemble bottom trim. Tighten the screws.
•Adjust the hinge spring to accommodate the panel weight, if necessary.
Loosen
Side
Trim
Screw
Adjust Nut Below |
Spring to Accommodate |
Panel Weight |
Loosen
Side
Trim
Screw
224D1889P009
Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.
GE Consumer & Industrial
Appliances
General Electric Company Louisville, KY 40225 ge.com
