Care and Cleaning
Stainless Steel Hood
Light bulbs
On some models, the lights are located on the sides, on the underside of the hood.
On some models, the lights arelocated on the front and back, on the underside of the hood.
NOTE: The glass cover should be removed only when cool.
CAUTION:
Before replacing the bulb, disconnect electrical power to the hood at the main fuse or circuit breaker or main power disconnect switch located on the control housing. Allow bulbs to cool before touching.
For safety, do not touch a hot bulb with bare hands or a damp cloth.
To change the light bulbs:
1.Remove the lamp lens cover by inserting a small
NOTE: Do not remove the outer trim ring (lamp assembly).
2.Grasp the bulb and pull it straight out.
3.Using gloves or a dry cloth, remove the new bulb from the packaging. (Wearing latex gloves may offer a better grip.) The bulb must be the same wattage,
4.Push the bulb straight all the way into the receptacle.
5.Replace the lens cover by inserting the three retaining tabs into the slots and pressing into place.
NOTE: For improved lighting, clean the glass cover frequently using a damp cloth. This should be done when the hood is completely cool.
6.Reconnect electrical power to the hood.
NOTE: Order replacement
These bulbs can be ordered from your GE supplier.
Use a small
Bulb
Outer trim ring (lamp assembly) Do not remove
Tab
Removable inner lamp lens cover
NOTE: Make sure the tabs are inserted into the slots.
ONLY use a new
Receptacle
Use gloves or cloth
NOTE: Do not touch the new halogen bulb with bare fingers. Skin oils can cause early- life bulb failure.
7
