GE ZV850, ZV855, ZV755, ZV750 Light bulbs, To change the light bulbs, Controls and Features

Controls and Features

Light bulbs

Stainless Steel Hood

NOTE: The glass cover should be removed only when cool.

CAUTION:

Before replacing the bulb, disconnect electrical power to the hood at the main fuse or circuit breaker. Allow bulbs to cool before touching.

Be sure to let the light cover and bulb cool completely.

Use a small flat-blade screwdriver to remove the lamp lens cover.

For safety, do not touch a hot bulb with bare hands or a damp cloth.

To change the light bulbs:

1.Remove the lamp lens cover by inserting a small

flat-blade screwdriver into each of the three	Tab
slots and gently prying it free.

NOTE: Do not remove the outer trim ring (lamp assembly).

Bulb

Outer trim ring (lamp assembly) Do not remove

Removable inner lamp lens cover

2.Grasp the bulb and pull it straight out.

3.Using gloves or a dry cloth, remove the new bulb from the packaging. (Wearing latex gloves may offer a better grip.) The bulb must be the same wattage, 120-volt, 25-watt halogen with a G-9 base. Early bulb failure may occur if wattage is too high.

4.Push the bulb straight all the way into the receptacle.

5.Replace the lens cover by inserting the three retaining tabs into the slots and pressing into place.

NOTE: For improved lighting, clean the glass cover frequently using a damp cloth. This should be done when the hood is completely cool.

6.Reconnect electrical power to the hood.

NOTE: Order replacement 120-volt, 25-watt halogen bulb with G-9 base, WB25X10020.

These bulbs can be ordered from your GE supplier.

NOTE: Make sure the tabs are inserted into the slots.

ONLY use a new 120-volt, 25-watt halogen bulb with a G-9 base.

Receptacle

Use gloves or cloth

NOTE: Do not touch the new halogen bulb with bare fingers. Skin oils can cause early lamp failure.

6