Anti-Tip Bracket Installation
36" All-Refrigerator and All-Freezer Units
Secure unit
to wall
• The "L"rods can be found inthe upper left
and right corners of the unit in the access
compartment. Look through the access
compartment to make sure the rods line
up with the anti-tip bracket.
• There are 2 washers and a hair pin cotter per
rod. Remove the washers and hair pin cotter
from the end of the rod.
Rotate and move the "L" rod into the slot
in the anti-tip bracket tab. Once it is in
the slot, rotate the "L" rod so the hook portion
is pointing down. The holes atthe front end
of the rod should be ina vertical position.
Do this to both sides.
• Pullout on the endof the rod tomake sure
it is secure in the bracket.
Locate the hole on the rod that is closest
to the unit. Ahair pin cotter will be put through
this hole to secure the rod. If this hole appears
to betoo far awag for a snug fit against
the unit, add the washers one at a time until
the pin will fit tightlg into the hole.
Align the straight section of the pin with
the holefrom the underside of the rod.Push
the pin up until it snaps into position. Pliers
mag be used. NOTE:The hair pin cotter must be
vertical when this step is completed to ensure
the "L" rod isengaged in the bracket.
Check the rod for tightness bg pulling forward.
Ifthe rod moves, remove the hair pin cotter
and place another washer on the rod.
Reinsert the pin.
Bend the left grille back into place (freezer onlg)
and replace the screws.
Replace the flat grille panel bg sliding
it under the flange at the top of the access
compartment and pushing the grille back
into place. Replace screws.
"L" RodPointingDown
Engagedin Bracket
"L" Rod
JJ 0
Wall Bracket
\
"L" Rod
i Washer
Hair PinCotter
isVertical
2
f
20