GE Monogram Side-by-Side Built-In Refrigerators Important facts about your ice, Ice storage bin

Ice storage bin

	Ice & Water Dispenser (on some models)
		Built-In Refrigerators
To remove:
Lift up the access door to reach the icemaker.		Access Door
Set the icemaker power switch to the OFF	Ice Storage Bin
position. With the access door closed, support
the storage bin at the bottom while slightly
lifting. Pull bin straight out .

To replace:

Rotate

Slide the bin back until the tab on the bin locks into the slot on the shelf. If the bin does not go all the way back, remove it and rotate the drive mechanism 1/4 turn. Then push the bin back again.

Drive

Mechanism

Important facts about your ice

&water dispenser

•Do not add ice from trays or bags to the storage bin. It may not crush or dispense well.

•Avoid overfilling glass with ice and use

of narrow or extra-tall glasses. Backed-up ice can jam the chute or cause the door in the chute to freeze shut . If ice is blocking the chute, poke it through with a wooden spoon.

•Beverages and foods should not be quick-chilled in the ice storage bin. Cans, bottles or food packages in the storage bin may cause the icemaker or auger to jam.

•To keep dispensed ice from missing

the glass, put the glass close to, but not touching, the dispenser opening.

•Some crushed ice may be dispensed even though you selected CUBES. This happens occasionally when a few cubes accidentally get directed to the crusher.

•After crushed ice is dispensed, some water may drip from the chute.

•Sometimes a mound of ice chips will form on the door in the ice chute. This condition is normal and usually occurs when you have dispensed crushed ice repeatedly. The ice chips will eventually evaporate.

•Dispensed water is not ice cold. For colder water, simply add crushed ice or cubes before dispensing water.

•The first glass of water dispensed may be warmer than the following ones. This is normal.

•To eliminate drips on the spill shelf, tilt

the glass in slightly when dispensing water.

11