Control Panel/Operation
Dishwasher
7Status Indicator Lights (indicators vary by model)
The Status display tells you what is happening while the dishwasher is in operation. The lights will come ON, indicating the sequence of the dishwasher operation.
SENSING | Displayed while the ExtraClean™ Sensor is measuring the amount of soil and |
| temperature of water. The dishwasher will adjust the selected cycle to achieve |
| optimal performance. |
|
|
| Displayed during prewash, indicating that dishes added now will still be cleaned. |
|
|
WASHING | Displayed during prewash, main wash and rinse periods. |
|
|
DRYING | Displayed during HEATED DRY. |
|
|
SANITIZED | Displayed when cycle has met sanitization conditions. |
|
|
CLEAN | Displayed when a wash cycle and enhancements are complete. |
8Time Remaining Display (on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display may adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may change from the factory setting as the unit customizes itself to actual home usage. During a delay start, the display will show hours of time remaining until the cycle starts.
9
START/RESET
START— After selecting the cycle and desired enhancements, press the START/RESET pad one time to ready the dishwasher to begin the cycle. Close the door to start the cycle or begin the DELAY START countdown. When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If you don’t want to change the settings, simply press the START/RESET pad one time to ready the dishwasher and close the door to begin the cycle.
NOTE: If the START/RESET light is flashing, the cycle has been interrupted.
Light will stop flashing after the dishwasher automatically pumps out the water. Close the door to allow the water to pump out (this takes approximately
70 seconds). When the light stops flashing, the dishwasher can be reprogrammed and restarted.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and press the START/RESET pad to begin the new cycle.
RESET— Open the door slowly to prevent
to cancel the cycle. Close the door. The dishwasher will pump out and turn off after 70 seconds.
10 Clean— The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete. You may remove the dishes at any time. Note the
NOTE: To turn off the double beep indicator (or
8