ZDBC240NBS – GE Monogram Stainless Steel Beverage Center

Dimensions and Specifications (in inches)

Installation Space

The Monogram® Beverage Center may b e installed beneath a
countertop or can be used free-s tanding.
• If installing between frameless cabinets, a 1/2"-wide filler strip
or side panel may be required. The filler strip will act as a spacer
between the door case and adjacent cabinet and will prevent
interference with cabinet door swing. T he width of the opening
must include filler panels.
Note: When installed, the door should project forward 1" of
adjacent 24"-deep cabinets.

Location Requirements

All Monogram Refrigeration Modules may be closed in on the top
and sides as long as the front is unobstruc ted for air circulation and
door swing.
• Do not install these products where the temperatures will go
below 55°F (13°C) or above 90°F (32°C) .
• Do not install where they will be subject to direct sunlight,
heat or moisture.
• These products are not designed to b e stacked one over the other.
For answers to your Monogram,
® GE Profile or
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
Listed by
Underwriters
Laboratories

34-1/2"-35"

24" Min.
23-3/4"
25-1/2"IncludingHandle23-3/4"1-1/2" Locate Outlet 9" Max.10-1/2" 23-3/4" Min. 34-1/4"to34-3/4"

Side-by-Side Installation

For a complete refreshment center, install a Monogram Wine Reserve
and Beverage Center together.
• Products must operate from separate properly grounded
receptacles.

Door Swing Clearances

All Monogram Refrigeration Modules are factor y set for a 110°
door swing.
When installed in a corner:
• Allow the minimum door swing clearances shown.
• The minimum clearance shown at 90° will allow full extension
of drawers and shelves.
A
Minimum to Wall
110°
110° Door
Swing 21-5/8"
23-5/8"
B
Minimum to Wall
90°
90° Door
Swing
10"
Minimum to Wall
4"
Minimum to Wall
Electrical
A 120V, 60Hz, 15 or 20 amp power supply is required. An individual
properly grounded branch circuit or circuit breaker is re commended.
Install a properly grounded 3-prong electr ical recessed into the
back wall as shown. Electrical must be locate d on rear wall as shown.
Note: GFCI (ground fault circuit interrup ter) is not recommended.
Specification Revised 4/ 06
120022