Installation Instructions
STEP 1A MODEL ZFSB23
MOVE REFRIGERATOR INDOORS
IMPORTANT: Doors and passageways into the installation location must allow the full depth of the refrigerator to pass through. ZFSB23 requires
a 31" min. opening. When the opening is less than these minimum widths, the top cap and doors must be removed.
NOTE: Skip this step if door removal is not required.
See instructions on next page, “To Move The Refrigerator Indoors.”
NOTE: To prevent damage, leave inside packaging, door spacer and outside protective wrap in place until the unit is moved to the installation location.
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best to remove one door at a time.
A. Remove 2 screws and springs on top of the refrigerator, one on each side. Push the top cap forward and lift up from the rear.
B.Remove 2 screws holding the top filler strip, lift off.
C.Open both doors. Remove the 2 toekick screws and pull forward to remove.
D.Disconnect the water line coupler by pushing against the collar on the left side. Disconnect wire harness.
E.Remove 2 screws holding top hinge to the case. Carefully lift off door.
Follow the same procedure to remove the fresh food door.
A
B
Hinge Screws
E
D
Wire Harness Water Line Coupler
C
Toekick Screw
6
