Installation Instructions
STEP 6 LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting the rollers located near the bottom hinges.
Raise
Rollers
Rollers have three purposes:
•The rollers adjust so that the door closes easily when opened about halfway. (Raise the front about 5/8"
[16 mm] from the floor.)
•Rollers adjust to allow the refrigerator to be firmly positioned on the floor and to prevent rocking when the doors are opened and closed.
•The rollers allow you to move the refrigerator from the wall for cleaning.
To Adjust the Rollers:
Roller Adjusting Screw
•Use a 3/8" hex socket or wrench to turn the adjustment screws. Turn the screws clockwise to raise the refrigerator, turn counterclockwise to lower it.
Roller Adjusting Screws
•Use a 5/16" hex socket to turn the screws for the rear rollers. Turn the screws clockwise to raise the refrigerator, counterclockwise to lower it.
STEP 7 LEVEL THE DOORS
If the doors are not evenly aligned at the top, the refrigerator door can be adjusted.
•Use a 7/16" hex socket or wrench to turn the door adjusting screw. Turn the screw to the right to raise the door, turn left to lower the door.
Doors Should
Align at Top
Raise
NOTE: A nylon plug is imbedded in the threads of the pin. The plug is designed to prevent the pin from turning. A wrench must be used to turn the pin.
•Turn the wrench one or two times. Open and close the refrigerator door to check alignment with the freezer door at the top. Adjust again if necessary.
STEP 8 SCREW DOWN SUPPORT LEG
Screw down the support leg until it touches the floor. This will prevent door misalignment.
9
