Installation Instructions
STEP 1 MODEL ZFSB25
(GO TO STEP 1A FOR MODEL ZFSB26)
MOVE REFRIGERATOR INDOORS
IMPORTANT: Door and passageways into the installation location require a 31" min. opening. If the opening is less than 31", the top cap and doors must be removed.
NOTE: Skip this step if door removal is not required. See instructions on next page, “To Move The Refrigerator Indoors.”
NOTE: To prevent damage, leave inside packaging, door spacer and outside protective wrap in place until the unit is moved to the installation location.
Hinge Screws
D
C
Wire Harness Water Line Coupler
REMOVE THE DOORS
The top cap must be removed to access hinges. It is best to remove one door at a time.
A. Remove 2 screws on top and 2 screws at the back of the top cap. Lift off top cap.
B. Open both doors. Remove the 2 toekick screws and pull forward to remove.
C. Disconnect the water line coupler by pushing against the collar on the left side. Disconnect wire harness.
D. Remove 2 screws holding top hinge to the case. Carefully lift off door.
Follow the same procedure to remove the fresh food door.
A
B
Toekick Screw
5
