GE Monogram ZGG540LBPSS dimensions Outdoor Built-in Cooktop, Specification Created 10/08

ZGG540NBPSS - Natural Gas Built-in Outdoor Grill ZGG540LBPSS - LP Gas Built-in Outdoor Grill

Dimensions and Installation Information (in inches)

12" Min. to Combustibles 4" Min. Clearance for Lid to Non-Combustibles

27" 53-7/8"

10-1/4" from

Bottom of

Support Flange

*25-1/2"

Countertop Depth

27" to Front

of Control Panel

28-1/2" to Front of Bullnose

*The weight of the grill is fully supported by the side trims. The back of the grill overlaps the back edge of the cutout.

Outdoor Built-in Cooktop

These grills are designed to be installed into a non- combustible enclousure.

• The grill drops into the opening and hangs from

26" the side flanges. It does not require support from the bottom.

• The cutout must be completely covered with non-combustible material such as stone, brick, ceramic tile, concrete board, etc. The countertop surface and edges must be flat and level.

•If the countertop has an overhang, it must be notched or cut back flush with the front face of the cabinet below. See notched detail below.

•Allow at least 12" minimum clearance at the back of the grill when the exhaust is directed to a window or surface that is difficult to clean. Allow at least 4" clearance behind the grill to allow the hood lid to open.

•Allow 12" minimum clearance on both sides and the back of the grill to adjacent vertical combustible construction.

•These gas grills cannot be used below any type of overhead construction.

•These grills are designed for outdoor use only. Do not locate the cooktop in a building, garage or other enclosed or semi-enclosed area.

•Locate the backside of the grill away from prevailing winds and avoid cooking in windy conditions.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

52-3/4"

Gas and

Electrical

Locations

24-1/2"

	Grill Cutout	10-7/8"
		Opening
36"		for Optional
	1-1/8" Min.	Access Doors
Min.

Specification Created 10/08 170134