
ZIDI240WII
GE Monogram®
ZIDS240WSS
GE Monogram
Dimensions and Installation Information (in inches)
Installation Space
Locate Outlet
|
| ||
| 9" | 24" Min. | |
Max. | |||
| Models | ||
| |||
| |||
|
| ||
Depth Including |
| ||
Handle: | |||
26" Stainless Steel | |||
| |||
Models Only |
|
Note:If installing between frameless cabinets, a 1/2" wide filler strip or side panel
may be required. The filler strip will act as a
spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening must include filler panels.
The cutout depth must be 24"
•Both models can be installed flush with stardard cabinetry.
•Designed to be
•White case and drawer sides, black vented toekick with optional stainless steel toekick supplied.
Additional Specifications:
•A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual property grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3- prong electrical receptacle recessed into the back wall as shown. Electrical must be located on rear wall as shown. Note: GFI (ground fault interrupter) is not recommended.
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.
For a complete food storage center, install two Monogram refrigeration modules
Note: Reversible door swing on wine chillers/reserves and beverage centers only. See below for combination cutout dimensions.
Important Note: Products must operate from separate, properly grounded receptacles.
Locate Outlets 24"
24" Min.
9"9"
Note: Additional cutout width may be required for models with custom panels.
Listed by
Underwriters
Laboratories
Specification Created 12/07 | 120032 |