GE Monogram ZIDI240WII GE Monogram Double-Drawer Refrigerator Module Custom panel required

ZIDI240WII

GE Monogram® Double-Drawer Refrigerator Module (Custom panel required)

ZIDS240WSS

GE Monogram Double-Drawer Refrigerator Module (Stainless steel)

Dimensions and Installation Information (in inches)

Grounding the Double-Drawer Refrigerator

IMPORTANT - (Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong

(grounding) wall receptacle to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

When a standard 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall

3/4” Overlay Panel Dimensions

Model ZIDI240WII requires customer- provided overlay door panel.

•The overlay panel must be secured to a 1/4" thick backer panel which slides into the trim. A .10" thick spacer panel must be placed between the custom and backer panel.

•A custom handle of your choice, supplied by your cabinet maker, must be installed on the overlay panel.

Overlay

Panel

Door

1/4"

Backer .10 Inch

Panel Spacer

outlet.

DO NOT, UNDER ANY CIRCUMSTANCES,

CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

DO NOT USE AN ADAPTER PLUG TO CONNECT THE REFRIGERATOR TO A 2- PRONG OUTLET.

DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.

A

12-1/2 lbs. max. B

12-1/2 lbs. max. B

1/4" Gap

3/4" Overlay Panel Dimensions (in inches)

	A (Width)	B (Height)
1/4" Backer	23-3/16"	14-11/16"
0.10" Spacer	22-1/2"	14-3/16"
3/4" Overlay	23-5/8"	15-1/16"

NOTE: Max. assembled drawer panel weight is 25 lbs.

IMPORTANT: Maintain a 1/4" gap between the panels when installed.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Assemble overlay panels with glue and screws.

•Center spacer panel on the backer panel, left to right and top to bottom. Secure the panels with glue.

•Center the spacer/backer panel on the overlay panel. Secure with glue and screws. Countersink screws into the backer panel.

Overlay Panel

Spacer Panel

Backer Panel

Listed by

Underwriters

Laboratories

Specification Revised 7/05 Specification Created 12/07 120032

120032