GE Monogram ZIFS36NM dimensions Monogram.“, Clearances, Accessory Grille Panel Kits

Models: ZIFS36NM

1 6
Download 6 pages 58.3 Kb
Page 5
Image 5
Electrical and Water Connection Locations

Monogram.

ZIFS36NM – GE Monogram 36" Built-In Stainless Steel All-Freezer

Electrical and Water Connection Locations

The water line can be routed through the floor or back wall.

The icemaker water line should be: –Approximately 3-1/2" from the floor on the back

wall, or 3-1/2" from the back wall on the floor. –At least 5" from either side of the opening.

Electrical Outlet Location 2-1/2"

ClearancesWhen Installed into a corner: 6"

5"

A 115 volt, 60 Hz. 15 or 20 amp power supply is recommended. An individual properly grounded branch circuit or circuit breaker is recommended, as noted on the rating plate.

Locate the electrical outlet within 5" x 7" shaded area shown.

–2-1/2" from the left side.

Between 74" and 81" from the floor.

75"

5"

3-1/2"

Water Location

Important: To insure a flush fit and access to the power cord, locate the electrical outlet as shown.

Clearances

Factory set for a 130° door swing. Order WX14X99 adjustable door stop to reduce swing to as little as 90°.

When Installed into a corner:

Allow 25" for a full 130° door swing. Allow 15" for pan removal. Allow 4" min. clearance when door swing is adjusted to a 90° opening for pan access, but pan removal is restricted.

130° Door Swing

25"

 

Minimum

 

to Wall

90° Door Swing

 

 

36-3/4"

90° door swing with

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

optional WX14X99

4"

 

Min.

 

door stop.

to Wall

When installing an All-Refrigerator and All-Freezer side-by-side, allow 25" for a full 130° door swing, or 15" min. on the hinge sides for pan access.

25"

 

 

0"

 

25"

 

 

 

 

 

 

Min. to

 

 

 

 

 

Min. to

Wall

130° Door Swing

 

 

 

130° Door Swing

Wall

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Accessory Grille Panel Kits

These models are factory set for 84" installation height. Adjustments to 83-1/2" or 84-1/2" heights can be made by changing the grille panel.

Order ZGCSS36RH (right hand) or ZGCSS36LH (left hand) Grille Panel Kit. These kits include 2 grille panels, for 83-1/2" and 84-1/2" installation heights.

Specification Revised 4/05 110154

ZUGSS Unified Grille Panel Kit is available for side-by-side installations. See Trim Kit descriptions.

ZUGSS Unified Grille Panel Kit

For side by side installation, order ZUGSS Grille Panel Kit. This kit provides one continuous panel to span the width of two products installed together for a unified appearance.

 

 

For answers to your Monogram,® GE Profileor

 

Listed by

GE appliance questions, visit our website at

R

Underwriters

GEAppliances.com or call

Laboratories

 

GE Answer Center® service, 800.626.2000.

 

 

Page 5
Image 5
GE Monogram ZIFS36NM Monogram.“, Clearances, Accessory Grille Panel Kits, Electrical and Water Connection Locations