GE Monogram ZTD910 Design Information, Advance Planning, Grounding the Appliance, Warming Drawer

Design Information

Warming Drawer

Advance Planning

•The drawer may be installed below a countertop, a cooktop, a single or double oven and side by side using 2 drawers.

•The warming drawer can be installed below approved cooktops. Allow 2" min. clearance from bottom of cooktop burner box to top of warming drawer cutout. See page 5.

•The warming drawer can be installed below approved ovens. Allow a 2" min. clearance between cutouts. Additional clearances may be required. See page 6.

•Electrical power cord is located on the right side of the warming oven. Locate the outlet within reach of the 56” long power cord in an adjacent cabinet, within 42” of the right side or 16” from the left side of the cutout. A recessed receptacle can be installed on the right side of the cutout, 7” max. from the rear of cabinet.

Grounding the Appliance

IMPORTANT - (Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

Do not use an extension cord or adapter plug with this appliance. Follow National electrical codes or prevailing local codes and ordi- nances.

This warming drawer must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit, and protected by a 15 or 20 amp circuit breaker or time delay fuse.

•A properly grounded 3-prong receptacle should be located within reach of the drawers’ 56” long power cord.

•Locate the receptacle in an adjacent cabinet.

–within 42” of the right side or,

–within 16” of the left side or,

–A recessed receptacle may be located on the right side of the cutout, 7” from the back of the cabinet. In this location, the excess power cord should be coiled and secured to the warming drawer side with the power cord clip.

•When two warming drawers are installed side to side, they can operate from the same receptacle.

Recessed Receptacle 7" Max. From Rear on Right Side.

Drill 1-1/2" Hole

For Power Cord For

Left or Right Side

Outlet Location

IMPORTANT: (Please read carefully).

The power cord of this appliance is equipped with a three-prong (grounding) plug that mates with a standard three-prong grounding wall receptacle to minimize the possibility of electric shock. The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the recep- tacle is properly grounded and has the correct polarity.

•Where a standard two-prong wall receptacle is encountered, it is the personal responsibil- ity and obligation of the customer to have it replaced with a properly grounded three- prong wall receptacle.

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

DO NOT USE AN EXTENSION CORD.

4